Week 17: 5/22/23-5/26/23: Daniel's Work
- Bechise Dyl
- Jun 2, 2023
- 1 min read
This week I was able to get most of the part for the base to start assemble it.

With that I was able to design the box that will house the components in them. This did take me a bit of time to do as I not that proficient in the AutoCAD software.


After I made the the design I was able to print them in the week and use them to see if all the components will fit in it. Unfortunately I did learn that print for the box would have took too long to print as a multiday print but I was able to find a similar print that was about the same size of what I need. With all the parts made that I did realized that the box was a too small to hold the components so a new one will be needed. Luckily I can use what I have to figure out the placement of the servo motors.

Comments